hitachi — DTC: P0113 (Flash code 22) Intake air temperature sensor fault (high voltage fault, open circuit or short to power supply circuit)

Electronic control fuel injection system (Common rail type) 1E-229 About IAT sensor Characteristics of intake air temperature sensor The output voltage of IAT sensor changes according to the intake air. The scan tool with CAN communication displays a fixed value when the value exceeds the threshold voltage. Therefore, judge as it is more than the threshold value if the value of 40 ° C ( 40 ° F) or 120 ° C (248 ° F) is not changed. The following illustration shows the correlation between physical value and voltage displayed in the scan tools with CAN communication. Tech2 and scan tools with KW communication can display both physical value and voltage. (V) 4.8691 Name 1. Signal 2.

GND 0.1797 -40 (-40) 120 (248) F TSWG0180 Step Action Value YES NO 19 1. Check for followings in the ground circuit between ECM and IAT sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 13. Go to Step 9.