Electronic control fuel injection system (Common rail type) 1E-231 On-board check procedure for sensors 3 1 2 4 TSWG0197 Name 1. Coupling connector between engine — the machine 2. Machine harness 3. Sensor connector 4. Engine harness 1. Disconnect the coupling connector, and check the sensor from engine harness connector. 2. Disconnect the connector from sensor, and short the wiring of sensor connector. 3. Check the harness from coupling connector for open circuit. If both steps 1 and 2 are faulty, repair the harness. Check from step 1 again. If only step 1 is faulty, replace the sensor. Step Item to be checked Inspection method Measuring condition Terminal No.
Normal value Abnormal value 6 Short circuit to power supply circuit Voltage measurement • Disconnect the sensor connector. • Key switch “ON” 72 - Ground 0V 18V or more 7 Open circuit/ high resistance Resistance measurement • Disconnect the sensor connector. • Key switch “OFF” 72 - Sensor connector signal terminal 100Ω or less 10 MΩ or more 8 Open circuit/ high resistance Resistance measurement • Disconnect the sensor connector. • Key switch “OFF” 60 - Sensor connector ground terminal 100Ω or less 10 MΩ or more