1E-232 Electronic control fuel injection system (Common rail type) DTC:
P0117 (Flash code 23) Engine coolant temperature sensor fault (low voltage fault, GND short, short circuit) Engine control module (ECM) Vehicle speed sensor signal Engine oil pressure sensor signal SV SV SV CKP HIGH signal CKP LOW signal Fuel temperature sensor signal Engine coolant temperature sensor signal Vcc 108 E-56 19 E-57 107 E-56 106 E-56 83 E-56 84 E-56 79 E-56 67 E-56 80 E-56 3 H-6 H-20 H-20 H-20 H-20 7 11 10 9 0.75 B/Y 0.75 L/Y 0.75 W/B 3 H-20 H-20 H-20 2 1 0.75 Y/G 0.75 B/Y 0.75 R/B 0.75 B/Y 0.75 B 2 E-93 1 E-93 1 E-90 2 E-90 1 E-76 E-76 E-76 2 3 0.5 V/W 0.5 Y Pulse matching box Engine coolant temperature sensor 2 E-98 1 E-98 Fuel temperature sensor Engine oil pressure sensor 3 E-90 CKP sensor A * 0.75 R CAN HIGH CAN LOW Engine control module (ECM) Vehicle speed sensor 37 E-57 18 E-57 4 H-6 A Meter Machine control unit CAN HIGH CAN LOW Engine coolant temperature gauge Machine trouble diagnosis monitor TSWG0078 Description of circuit Main trouble symptom The engine coolant temperature (ECT) sensor detects the engine coolant temperature.
The ECT sensor is installed near the thermostat housing. The ECT sensor is the thermistor type and the value of resistance inside the sensor changes according to the temperature. If the temperature is high, the resistance becomes low; if the temperature is low, the resistance becomes high. The engine control module (ECM) is connected to the ECT sensor via signal circuit and ground circuit, and energizes +5 V power supply to the signal circuit. ECM recognizes the applied voltage, which varies with change in the resistance of ECT sensor according to temperature (If the temperature is high, the voltage becomes low; if the temperature is low, the voltage becomes high), as an input signal.
Deterioration of startability at low temperatures Black smoke emitted Output lowering depending on conditions Preconditions when DTC is set Key switch input voltage is 16V or more. DTC P1630 or P1633 is not detected. DTC set condition ECT sensor voltage is 0.1 V or less. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on.