hitachi — DTC: P0117 (Flash code 23) Engine coolant temperature sensor fault (low voltage fault, GND short, short circuit)

Electronic control fuel injection system (Common rail type) 1E-233 Back-up mode If the intermittent trouble is suspected, followings may be the cause. Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage.

Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part. Coolant temperature default setting (at starting: 20 ° C { 4 ° F}, at running: 80 ° C {176 ° F}) EGR stopped Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure).

Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Diagnostic aid DTC may be set at a overheat condition. After starting the engine, the engine coolant temperature rises and when it exceeds 82 ° C (180 ° F), the thermostat begins to open and the engine coolant temperature is stabilized. To make sure the correct performance of the ECT sensor, check with various temperatures using the reckoner table between temperature and resistance. If the sensor is faulty, operationality may be affected. Test description Numbers below indicate step numbers in the chart. 3.

In case of present trouble, the “Engine coolant temperature sensor” displays more than the specified value. In this case, identify the cause by referring to “Diagnostic aid”. 5. If the “Engine coolant temperature sensor” displays more than the specified value when the ECT sensor connector is removed, the circuit beyond the sensor is normal including ECM. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Perform “OBD system check”, and Go to Step 2. 2 Is the scan tool (KW communication) available? — Go to Step 3. Go to Step 13. 3 Check the value for ECT sensor using scan tool. 1. Connect the scan tool. 2. Start the engine. 3.

Check the value for “Engine coolant temperature sensor” using scan tool. Is the “Engine coolant temperature sensor” less than the specified value? 0.1V Go to Step 4. Go to “Diagnostic aid”. 4 Check for installation condition of the ECT sensor, ECM and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 11. Go to Step 6.