hitachi — DTC: P0117 (Flash code 23) Engine coolant temperature sensor fault (low voltage fault, GND short, short circuit)

1E-234 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 5 1. Turn the key switch to “OFF”. 2. Disconnect the ECT sensor connector. 3. Turn the key switch to “ON”. 4. Check the value for “Engine coolant temperature sensor” using scan tool. Is the “Engine coolant temperature sensor” more than the specified value? 4.8V Go to Step 7. Go to Step 6. 6 1. Check for followings in the signal circuit between ECM and ECT sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Short circuit to ECT sensor ground circuit • Short circuit to ground 2.

Measure the resistance of ECT sensor to check that the value is within normal range. 3. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 11. Go to Step 8. 7 Replace the ECT sensor. Is the procedure completed? — Go to Step 11. — 8 Is EMPS available? — Go to Step 9. Go to Step 10. 9 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM.

Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 11. Go to Step 10. 10 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 11. —