Electronic control fuel injection system (Common rail type) 1E-235 Step Action Value YES NO 11 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P0117 detected? — Go to Step 2. Go to Step 12. 12 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 13 1. Start the engine. 2. Check the display of the engine coolant temperature.
Display of engine coolant temperature is 214°C (419°F) due to back-up mode after fault judgment. 3. Does the display of “Engine coolant temperature” show error value? 214°C (419°F) (Displayed error value) Go to Step 14. Go to Step 11. 14 Check for installation condition of the ECT sensor, ECM and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair or replace as required. Is the procedure completed? — — Go to Step 15. 15 1. Check for followings in the signal circuit between ECM and ECT sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note:
If breaker box is not available, refer to “On- board check procedure for sensors”. • Short circuit to ECT sensor ground circuit • Short circuit to ground 2. Measure the resistance of ECT sensor to check that the value is within normal range. 3. If the trouble is detected, repair or replace as required. Is the procedure completed? — — Go to Step 7.