hitachi — DTC: P0182 (Flash code 211) Fuel temperature sensor fault (low voltage fault, GND short)

Electronic control fuel injection system (Common rail type) 1E-247 Recovery from failure Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part.

Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Diagnostic aid When the engine cold (before starting engine), check if the temperatures of the FT sensor and IAT sensor are close. If the intermittent trouble is suspected, followings may be the cause.

Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Test description Numbers below indicate step numbers in the chart. 3. In the case of present trouble, the “Fuel temperature sensor” displays more than the specified value. In this case, identify the cause by referring to “Diagnostic aid”. 5. If the “Fuel temperature sensor” displays more than the specified value when the FT sensor connector is removed, the circuit beyond the sensor is normal including ECM. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Perform “OBD system check”, and Go to Step 2.

2 Is the scan tool (KW communication) available? — Go to Step 3. Go to Step 13. 3 Check the value for FT sensor using scan tool. 1. Connect the scan tool. 2. Start the engine. 3. Check the value for “Fuel temperature sensor” using scan tool. Is the “Fuel temperature sensor” less than the specified value? 0.1V Go to Step 4. Go to “Diagnostic aid”. 4 Check for installation condition of the FT sensor, ECM and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 11. Go to Step 5. 5 1. Turn the key switch to “OFF”. 2. Disconnect the FT sensor connector. 3.

Turn the key switch to “ON”. 4. Check the value for “Fuel temperature sensor” using scan tool. Is the “Fuel temperature sensor” more than the specified value? 4.8V Go to Step 7. Go to Step 6.