hitachi — DTC: P0182 (Flash code 211) Fuel temperature sensor fault (low voltage fault, GND short)

1E-248 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 6 1. Check for followings in the signal circuit between ECM and FT sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Short circuit to FT sensor ground circuit • Short circuit to ground 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 11. Go to Step 8. 7 Replace the FT sensor. Is the procedure completed? — Go to Step 11. — 8 Is EMPS available? — Go to Step 9. Go to Step 10. 9 1. Check the version of ECM software. 2.

Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 11. Go to Step 10. 10 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 11. —