hitachi — DTC: P0201 (Flash code 271) Open circuit in injection nozzle #1 drive system

Electronic control fuel injection system (Common rail type) 1E-277 Breaker box inspection procedure Perform the inspection in the following procedure if there is such an instruction to use breaker box in the step. After inspection, return to the diagnostic step. Name 1. Breaker box 2. DMM Step Action Value YES NO 13 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P0201 detected? — Go to Step 2. Go to Step 14.

14 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. Step Item to be checked Inspection method Measuring condition Terminal No. Normal value Abnormal value 4 Open circuit/ high resistance Resistance measurement • Remove the coupling connector. • Key switch “OFF” 119 - Coupling connector (H-94) No. 2 terminal 100 Ω or less 10 MΩ or more