Electronic control fuel injection system (Common rail type) 1E-303 DTC:
P0219 (Flash code 543) Overrun Engine control module (ECM) Common rail pressure sensor signal G sensor signal 5V CKP HIGH signal CKP LOW signal 98 E-56 101 E-56 82 E-56 100 E-56 90 E-56 87 E-56 108 E-56 107 E-56 106 E-56 5 H-20 H-20 H-20 H-20 H-20 14 6 13 12 3 H-20 H-20 H-20 2 1 0.75 L 0.75 B 0.5 Br 0.5 L/W 0.5 R 0.5 G 0.5 L 0.5 L/W 0.75 B/W 0.5 L 0.5 Br 2 E-98 1 E-98 CKP sensor 1 E-112 2 E-112 3 E-112 1 E-113 3 E-113 2 E-113 Common rail pressure sensor G sensor TSWG0070 Description of circuit Action taken when DTC is set The engine control module (ECM) detects the engine speed based on the crankshaft position (CKP) sensor signal.
The ECM stops the fuel injection to lower the engine speed when the engine speed exceeds the specified value. Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Back-up mode Main trouble symptom Limited injection amount 1 Limitation is lifted if the speed decreases Output lowering Preconditions when DTC is set Recovery from failure Key switch input voltage is 16V or more. Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. DTC set condition • The engine speed exceeds setting value