1E-304 Electronic control fuel injection system (Common rail type) The conditions to clear the MIL/DTC Crankshaft position (CKP) sensor, G sensor fault (signal fault etc.) Engine body fault (supply pump, injector, body, etc.) ECM internal trouble Check the connector for poor contact, the harness for fault such as wear or bend, and the wire inside the harness for loosened wire causing short circuit to other circuits. Also, perform the function diagnosis to check the operation and control of each part. Repair if faulty. When this DTC is detected, check the engine body for trouble such as seizure and breakage.
The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Diagnostic aid Load (fluid pressure pump etc.) is light. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 Confirm the driving status (improper operation of the vehicle due to engine over speed).
(Interview the operator for driving status in the past.) Has the vehicle been operated improperly? — Go to Step 3. Go to Step 4. 3 Tell the operator that it is the over speed caused by improper operation, and give a driving instruction. Is the procedure completed? — Go to Step 4. — 4 Check for adverse effect (fault in the engine body) caused by the engine over speed. Repair or replace if fault is found. Is the procedure completed? — Go to Step 5. — 5 Check the DTC again. 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Turn the key switch to “OFF” for more than 10 seconds. 3.
Test run with the “Preconditions when DTC is set”. 4. Check the DTC. Is DTC detected? — Go to each DTC diagnosis. Verify repair.