hitachi — DTC: P0237 (Flash code 32) Boost sensor pressure fault (low voltage fault, open circuit)

1E-310 Electronic control fuel injection system (Common rail type) About boost pressure sensor Breaker box inspection procedure Perform the inspection in the following procedure if there is such an instruction to use breaker box in the step. After inspection, return to the diagnostic step. 1 2 3 TSWG0062 Name 1. Sensor ground 2. Sensor signal 3. Sensor power supply Name 1. Breaker box 2. DMM Characteristics of boost pressure sensor The output voltage of boost pressure sensor changes according to the boost pressure. The scan tool with CAN communication displays a fixed value when the value exceeds the threshold voltage.

Therefore, judge as it is more than the threshold value if the value of 40 MPa (5802 psi) or 350 MPa (50763 psi) is not changed. When error occurs, error value (508 MPa {73679 psi}) is displayed. The following illustration shows the correlation between physical value and voltage displayed in the scan tools with CAN communication. Tech2 and scan tools with KW communication can display both physical value and voltage. (V) 4.75026 0.100082 40(5802) 350(50763) MPa(psi) TSWG0063