Electronic control fuel injection system (Common rail type) 1E-309 Step Action Value YES NO 15 Check for installation condition of the boost pressure sensor connector, ECM connector and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 13. Go to Step 16. 16 1. Check for followings in the power supply circuit between ECM and boost pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair as required.
Is the trouble detected? — Go to Step 12. Go to Step 17. 17 1. Check for followings in the signal circuit between ECM and boost pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Short circuit to boost pressure sensor ground circuit • Short circuit to ground • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 8.