hitachi — DTC: P0237 (Flash code 32) Boost sensor pressure fault (low voltage fault, open circuit)

1E-308 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 8 Replace the boost pressure sensor. Is the procedure completed? — Go to Step 12. — 9 Is EMPS available? — Go to Step 10. Go to Step 11. 10 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 12. Go to Step 11. 11 Replace the ECM. Note:

EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 12. — 12 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P0237 detected? — Go to Step 2. Go to Step 13. 13 Check if other DTC is detected. Is other DTC detected?

— Go to each DTC diagnosis. Verify repair. 14 1. Start the engine. 2. Check the display of boost pressure sensor. Does the display of “Boost pressure sensor” show error value? 508 MPa (73679 psi) (Displayed error value) Go to Step 15. Go to “Diagnostic aid”.