hitachi — DTC: P0238 (Flash code 32) Boost pressure sensor fault (high voltage fault, short to power supply circuit, ground open circuit)

1E-316 Electronic control fuel injection system (Common rail type) About boost pressure sensor Name 1. Sensor ground 2. Sensor signal 3. Sensor power supply 1 2 3 TSWG0062 Step Action Value YES NO 16 1. Check the signal circuit between ECM and boost pressure sensor for short circuit to the power supply circuit or ignition power supply circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. Important: If the boost pressure sensor circuit is shorted to the power supply circuit, the sensor may be broken. 2. If the trouble is detected, repair as required. Is the trouble detected?

— Go to Step 12. Go to Step 17. 17 1. Check for followings in the ground circuit between ECM and boost pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 8.