1E-324 Electronic control fuel injection system (Common rail type) On-board check procedure for sensors 1. Disconnect the coupling connector, and check the sensor from engine harness connector. 2. Disconnect the connector from sensor, and short the wiring of sensor connector. 3. Check the harness from coupling connector for open circuit. If both steps 1 and 2 are faulty, repair the harness. Check from step 1 again. If only step 1 is faulty, replace the sensor. 3 1 2 4 Name 1. Coupling connector between engine — the machine 2. Machine harness 3. Sensor connector 4. Engine harness TSWG0197 Step Item to be checked Inspection method Measuring condition Terminal No.
Normal value Abnormal value 6 Open circuit/ high resistance Resistance measurement • Disconnect the sensor connector. • Key switch “OFF” 106 - Sensor connector (−) terminal 107 - Sensor connector (+) terminal 100 Ω or less 10 MΩ or more Short circuit to ground Resistance measurement • Disconnect the sensor connector. • Key switch “OFF” 106 - Ground 107 - Ground 10 MΩ or more 100 Ω or less Short circuit between terminals Resistance measurement • Disconnect the sensor connector. • Key switch “OFF” 106 - 107 10 MΩ or more 100 Ω or less Short circuit to power supply circuit Voltage measurement • Disconnect the sensor connector. • Key switch “ON” 106 - Ground 107 - Ground 0V 18V or more