Electronic control fuel injection system (Common rail type) 1E-325 DTC: P0336 (Flash code 15) Crank sensor fault (signal fault) Engine control module (ECM) Common rail pressure sensor signal G sensor signal 5V CKP HIGH signal CKP LOW signal 98 E-56 101 E-56 82 E-56 100 E-56 90 E-56 87 E-56 108 E-56 107 E-56 106 E-56 5 H-20 H-20 H-20 H-20 H-20 14 6 13 12 3 H-20 H-20 H-20 2 1 0.75 L 0.75 B 0.5 Br 0.5 L/W 0.5 R 0.5 G 0.5 L 0.5 L/W 0.75 B/W 0.5 L 0.5 Br 2 E-98 1 E-98 CKP sensor 1 E-112 2 E-112 3 E-112 1 E-113 3 E-113 2 E-113 Common rail pressure sensor G sensor TSWG0070 Description of circuit Preconditions when DTC is set The crankshaft position (CKP) sensor detects the engine speed.
When the sensing hole installed in the flywheel housing passes the tip of the CKP sensor, a voltage is generated and turned into a pulse signal. The engine control module (ECM) reads this pulse signal, and obtains the engine speed and injection timing based on the signal. Cam pulse is normal. DTC P0335, P0336, P0340, P0341, or P1345 is not detected. Engine under operation DTC set condition Number of pulse for crank signal is mismatched.
Main trouble symptom Action taken when DTC is set Output lowering White smoke emitted Intense engine vibration possible Engine stall possible (restart is possible when G sensor is normal.) Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Back-up mode Control based on G sensor when it is normal