hitachi — DTC: P0336 (Flash code 15) Crank sensor fault (signal fault)

1E-326 Electronic control fuel injection system (Common rail type) Recovery from failure Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part. For crank sensor fault, DTC won’t be detected unless the engine cranks for 14 revolutions.

Especially when running with low speed such as idling, engine stalls before cranking for 14 revolutions if no crank signal exist. In this case, the back-up mode will not be active because DTC is not detected. Therefore, the engine can be restarted even after it stalls, making it difficult to identify the fault. If the engine experienced stall, raise the engine speed up to No Load Max, and check if crank sensor fault is detected while cranking for 14 revolutions. If crank sensor fault is detected at No Load Max, DTC will be detected. If intermittent trouble is found, raise the engine speed up to No Load Max, and check if DTC P0355 is detected.

Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Diagnostic aid If the intermittent trouble is suspected, followings may be the cause.

Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 Check for installation condition of the crankshaft position (CKP) sensor. 1. Turn the key switch to “OFF”. 2. Visually check the sensor for installation condition such as play or looseness. 3. If the trouble is detected, repair as required. Is the procedure completed? — Go to Step 3. — 3 Check for installation condition of the CKP sensor, ECM and coupling connector. 1. Check for play or looseness in the connection. 2.

If the trouble is detected, repair or replace as required. Is the procedure completed? — Go to Step 4. —