Electronic control fuel injection system (Common rail type) 1E-327 Step Action Value YES NO 4 Check the DTC again. 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Turn the key switch to “OFF” for more than 10 seconds. 3. Start the engine, and test run with the “Preconditions when DTC is set”. 4. Check the DTC. Is DTC detected? — Go to Step 5. Go to Step 12. 5 1. Check the CKP sensor circuit for short circuit to other signal circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2.
If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 12. Go to Step 6. 6 Check the CKP sensor body. 1. Turn the key switch to “OFF”. 2. Remove the harness from the CKP sensor. 3. Measure the resistance between the sensor connector terminals. 4. Remove the CKP sensor, and check the sensor tip for scratch or damage. Is the CKP sensor normal? Between terminals: 108.5 — 142.5Ω; Each terminal to ground: ∞Ω (at normal temperature) Go to Step 8. Go to Step 7. 7 Replace the CKP sensor. Is the procedure completed? — Go to Step 12. — 8 1. Visually check the flywheel for chipped tooth. 2. If the trouble is detected, replace it. Is the trouble detected?
— Go to Step 12. Go to Step 9. 9 Is EMPS available? — Go to Step 10. Go to Step 11.