hitachi — DTC: P0340 (Flash code 14) G sensor fault (no signal)

1E-332 Electronic control fuel injection system (Common rail type) The conditions to clear the MIL/DTC Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part. The cam gears are out of installation phase by one tooth.

The cam gears are out of installation phase by one tooth. The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Diagnostic aid If the intermittent trouble is suspected, followings may be the cause. Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Step Action Value YES NO 1 Perform the OBD system check.

Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 Check for installation condition of the G sensor. 1. Turn the key switch to “OFF”. 2. Visually check the sensor for installation condition such as play or looseness. 3. If the trouble is detected, repair as required. Is the procedure completed? — Go to Step 3. — 3 Check for installation condition of the G sensor, ECM and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair or replace as required. Is the procedure completed? — Go to Step 4. — 4 Check the DTC again. 1. Clear the DTC.

Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Turn the key switch to “OFF” for more than 10 seconds. 3. Start the engine, and test run with the “Preconditions when DTC is set”. 4. Check the DTC. Is DTC detected? — Go to Step 5. Go to Step 15. 5 Remove the G sensor, and check the sensor tip for scratch or damage. Is the G sensor normal? — Go to Step 6. Go to Step 9.