hitachi — DTC: P0340 (Flash code 14) G sensor fault (no signal)

Electronic control fuel injection system (Common rail type) 1E-333 Step Action Value YES NO 6 1. Check for followings in the power supply circuit between ECM and G sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance • Short circuit to ground 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 15. Go to Step 7. 7 1. Check for followings in the signal circuit between ECM and G sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note:

If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance • Short circuit to power supply circuit or ignition power supply circuit 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 15. Go to Step 8. 8 1. Check for followings in the shield circuit between ECM and G sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance • Short circuit to power supply circuit or ignition power supply circuit 2.

If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 15. Go to Step 10. 9 Replace the G sensor. Is the procedure completed? — Go to Step 10. —