hitachi — DTC: P0340 (Flash code 14) G sensor fault (no signal)

1E-334 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 10 1. Visually check the camshaft gear for fault. 2. Check the alignment mark in the timing gear. 3. If the trouble is detected, repair or replace it. Is the trouble detected? — Go to Step 15. Go to Step 11. 11 Replace the supply pump. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 14. — 12 Is EMPS available? — Go to Step 13. Go to Step 14. 13 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note:

EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 15. Go to Step 14. 14 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 15. — 15 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC.

Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P0340 detected? — Go to Step 2. Go to Step 16. 16 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair.