hitachi — DTC: P0340 (Flash code 14) G sensor fault (no signal)

1E-336 Electronic control fuel injection system (Common rail type) On-board check procedure for sensors 1. Disconnect the coupling connector, and check the sensor from engine harness connector. 2. Disconnect the connector from sensor, and short the wiring of sensor connector. 3. Check the harness from coupling connector for open circuit. If both steps 1 and 2 are faulty, repair the harness. Check from step 1 again. If only step 1 is faulty, replace the sensor. 3 1 2 4 TSWG0197 Name 1. Coupling connector between engine — the machine 2. Machine harness 3. Sensor connector 4. Engine harness Step Item to be checked Inspection method Measuring condition Terminal No.

Normal value Abnormal value 6 Open circuit/ high resistance Resistance measurement • Disconnect the sensor connector. • Key switch “OFF” 99 - Sensor connector power supply terminal 100 Ω or less 10 MΩ or more Short circuit to ground Resistance measurement • Disconnect the sensor connector. • Key switch “OFF” 99 - Ground 10 MΩ or more 100 Ω or less 7 Open circuit/ high resistance Resistance measurement • Disconnect the sensor connector. • Key switch “OFF” 98 - Sensor connector signal terminal 100 Ω or less 10 MΩ or more Short circuit to power supply circuit Voltage measurement • Disconnect the sensor connector.

• Key switch “ON” 98 - Ground 0V 18V or more 8 Open circuit/ high resistance Resistance measurement • Disconnect the sensor connector. • Key switch “OFF” 100 - Sensor connector shield terminal 100 Ω or less 10 MΩ or more Short circuit to power supply circuit Voltage measurement • Disconnect the sensor connector. • Key switch “ON” 100 - Ground 0V 18V or more