hitachi — DTC: P0341 (Flash code 14) G sensor fault (signal fault)

Electronic control fuel injection system (Common rail type) 1E-337 DTC: P0341 (Flash code 14) G sensor fault (signal fault) Engine control module (ECM) Common rail pressure sensor signal G sensor signal 5V CKP HIGH signal CKP LOW signal 98 E-56 101 E-56 82 E-56 100 E-56 90 E-56 87 E-56 108 E-56 107 E-56 106 E-56 5 H-20 H-20 H-20 H-20 H-20 14 6 13 12 3 H-20 H-20 H-20 2 1 0.75 L 0.75 B 0.5 Br 0.5 L/W 0.5 R 0.5 G 0.5 L 0.5 L/W 0.75 B/W 0.5 L 0.5 Br 2 E-98 1 E-98 CKP sensor 1 E-112 2 E-112 3 E-112 1 E-113 3 E-113 2 E-113 Common rail pressure sensor G sensor TSWG0070 Description of circuit DTC set condition The G sensor is installed to supply pump and identifies the cylinder.

When the pulser passes the tip of the G sensor, a voltage is generated and turned into a pulse signal. The engine control module (ECM) reads this pulse signal, and identifies the cylinder based on the signal. When unnecessary G sensor pulse is detected, or when shortage of G sensor pulse is detected. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Main trouble symptom Engine does not start. Behavior does not change during engine running. Back-up mode Preconditions when DTC is set Engine running based on crank when it is normal After engine stops:

Unable to identify cylinder (unable to restart) Key switch input voltage is 16V or more. Crank pulse is normal. DTC P0335, P0336, P0340, P0341, P1345, or P1635 is not detected. Engine under operation