hitachi — DTC: P0380 (Flash code 66) Glow relay circuit fault

Electronic control fuel injection system (Common rail type) 1E-343 DTC: P0380 (Flash code 66) Glow relay circuit fault (*: Specifications (fuse current value etc.) vary depending on each machine. Refer to the machine manual.) (100A)* B Starter C Battery B Generator (15A)* (60A)* Glow relay Main relay Starter cut relay Starter cut relay (10A)* 1 H-22 0.5 B/W 1 H-1 10 E-57 Key switch E-57 14 Glow relay control Glow plug Engine control module (ECM) Starter cut relay signal TSWG0072 Note: The QOS circuit is the same for both the starter ECM control specifications and the safety relay specifications. DTC set condition Glow relay drive indication signal is unmatched with glow relay monitor signal.

Description of circuit Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. The glow relay cuts off the power supply voltage (24 V) to the glow plug, and turns “ON” when the signal from ECM is input. The ECM recognizes the starter switch “ON” signal, and outputs the “ON” signal to the glow relay. Back-up mode Main trouble symptom Back-up: No back-up action Startability deteriorates at low temperatures. Recovery from failure Preconditions when DTC is set Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure.

Key switch input power supply voltage is 16 V or more and 32 V or less. A B Br C (ON) (ST) OFF ON START A B ACC Br C (ON) (ST) OFF ON START B Br (ON) C (ST) OFF ON START B ACC Br (ON) C (ST) OFF ON START