1E-30 Electronic control fuel injection system (Common rail type) Battery cable Caution: If the card is not inserted properly and the unit is switched on, “NO PCMCIA CARD INSERTED” will appear. If that is the case, turn off the power and redo the insertion of the PCMCIA Card. This cable should be used, in the case where no power is supplied even when the Tech2 is connected to the machine through the machine DLC cable, or where the machine works with a higher voltage than the operating voltage of the unit. When connecting the cable, pay heed to the polarities of the clamps.
(The black clip of the cable is to be connected to the negative terminal of the battery and the red clip to the positive terminal.) Connection Check to see whether the DLC cable is fitted with an adapter compatible with the machine. Caution: In the case of a 24-V machine, connect to battery on the body ground side to take out 12 V. Note: Before connecting the cable to the machine, verify that the key switch is in the “OFF” position. Caution: In the case of a 24-V machine, connect to battery on the body ground side to take out 12 V. How to connect Tech2 1. Insert the PCMCIA Card with the latest version of ISUZU system into the Tech2. 2. Connect the SAE 16/19 adapter to the DLC cable. 3.
Connect the DLC cable to the Tech2. 4. Make sure that the key switch is OFF. 5. Connect the SAE 16/19 adapter of Tech2 to the machine DLC. Caution: Connecting method varies depending on each machine. Refer to the machine’s manual. The following description is for the machine with DLC. TSWG0141 Power socket cable (AC/DC adapter) This is used to check the captured data by operating Tech2 away from the machine. Caution: Be sure to use the power socket cable adapted to local standards. Otherwise, it may result in failure of Tech2 or power socket cable due to different voltage and current depending on regions.
Check items before use VCI Check to see whether the VCI module is securely inserted and whether the fastening latch bar of the VCI module is located on the left-hand end. Attach the DLC cable and fasten it by tightening the two lock screws. TSWG0118 PCMCIA Card Check to see whether the slot (upper side) has this card inserted with its “Tech2” label side up.