Electronic control fuel injection system (Common rail type) 1E-31 6. Turn the ignition switch to ON and press the “PWR” key of the Tech2. 7. Check the display of the Tech2. If the test ends normally, “Pass” will appear and one short sound will be heard. If the test ends abnormally, “Fail” will appear and three short sounds will be heard. Note: If the LED fails to come on, it means a malfunction of the LED, not a malfunction of the SHIFT key. Absence of sound means a malfunction of the Sound Transducer *1 , but the unit can be used as is, without any problem. *1. Sound Transducer: The sound is intended to indicate the completion of a data setup or an error in a setup. TSWG0110 Caution:
Be sure to turn off the power of Tech2 when installing/removing the PCMCIA card. Operation procedure Start-up The Tech2 is designed to automatically conduct a self- function test every time it is started. Immediately after the unit has been switched on, the “SYSTEM INITIALIZING” message will appear. During this period, POST (Power-On Self Test) is carried out, and if the test ends normally, a sound will be issued at the completion of the test. Simultaneously, the LED of the SHIFT key will momentarily come on. This is also meant to check the normality of the LED. Pass: Normal Fail: Abnormal TSGW0085 Note:
Only for UART, SCI, RTC, and CLKMEM in particular, the test result may appear as “Fail” without this meaning any trouble. For “Fail” above, refer to “Tech2 Self Test in Tool Options”. IRAM: Internal RAM ERAM: External RAM UART: Universal Asynchronous Receiver and Transmitter MCU: MC68332 Microcontroller QSPI: Queued Serial Peripheral Interface SCI: Serial Communication Interface TPU: Time Processor Unit RTC: Real-Time Clock CLKMEM: Clock Memory KEYPAD: Keypad SYSTEM INITIALIZING TSWG0084 Display of POST results: