Electronic control fuel injection system (Common rail type) 1E-345 Step Action Value YES NO 7 1. Check for following in the circuit between the fuse and the glow relay. • Open circuit • Short circuit to ground circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 8. 8 1. Check for followings in the circuit between glow relay and ECM using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • Short circuit to ground circuit • High resistance 2. If the trouble is detected, repair as required.
Is the trouble detected? — Go to Step 12. Go to Step 9. 9 1. Turn the key switch to “OFF”. 2. Remove the glow relay. 3. Turn the key switch to “ON”. 4. Check for “Glow relay” on the data display using scan tool. Is the “Glow relay” displayed “OFF”? — Go to Step 11. Go to Step 10. 10 1. Check the circuit between glow relay and ECM for short circuit to the power supply circuit or ignition power supply circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 11.
11 Replace the glow relay. Is the procedure completed? — Go to Step 12. — 12 Is EMPS available? — Go to Step 13. Go to Step 14.