Electronic control fuel injection system (Common rail type) 1E-349 The conditions to clear the MIL/DTC Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part. The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again.
Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Diagnostic aid If the intermittent trouble is suspected, followings may be the cause. Blown lamp bulb Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Test description Numbers below indicate step numbers in the chart. 2.
If the lamp does not come on with the key switch “ON”, open circuit, short circuit to the ground circuit, blown light bulb, or ECM fault is suspected. 2. If the lamp does not go OFF, short circuit to the ground circuit, meter circuit fault, or ECM fault is suspected. 4. If the lamp goes off when the ECM connector is removed, the circuit beyond the ECM is normal including meter. 7. If the lamp comes on when the lamp control terminal is shorted to the ground, the circuit beyond the ECM is normal including meter. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Perform “OBD system check”, and Go to Step 2. 2 1. Turn the key switch to “ON”. 2.
Check if the QOS indicator lamp is ON. Does the QOS indicator lamp come on? — Go to Step 3. Go to Step 7. 3 Turn the key switch “ON” and wait for 10 seconds. Does the QOS indicator lamp go OFF? — Go to “Diagnostic aid”. Go to Step 4. 4 1. Turn the key switch to “OFF”. 2. Remove the connector from the ECM. 3. Turn the key switch to “ON”. 4. Check if the QOS indicator lamp is ON. Does the QOS indicator lamp go OFF? — Go to Step 12. Go to Step 5. 5 Check for installation condition of the meter, ECM connector and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 14. Go to Step 6.