hitachi — DTC: P0381 (Flash code 67) Glow plug lamp circuit fault

1E-348 Electronic control fuel injection system (Common rail type) DTC: P0381 (Flash code 67) Glow plug lamp circuit fault (*: Specifications (fuse current value etc.) vary depending on each machine.

Refer to the machine manual.) (15A)* A A Machine trouble diagnosis monitor Meter Tachometer Diagnosis lamp Engine oil pressure lamp QOS indicator lamp Boost temperature lamp Machine control unit CAN HIGH CAN LOW Engine control module (ECM) 37 E-57 18 E-57 6 E-57 8 E-57 17 E-57 11 E-57 7 E-57 Diagnosis lamp control Engine oil pressure lamp control QOS indicator lamp control Boost temperature lamp control CAN HIGH CAN LOW Tachometer signal TSWG0075 Description of circuit DTC set condition The QOS indicator lamp is installed in the meter. The engine control module (ECM) turns the QOS indicator lamp on to tell the glow plug operation when the key switch is turned “ON”.

The ECM detects the glow plug operating condition, and turns the lamp off upon completion of preheat. Glow lamp indication signal is unmatched with glow lamp monitor signal. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Main trouble symptom Operationality is not affected. Back-up mode Preconditions when DTC is set Back-up: No back-up action Key switch input voltage is 16V or more. DTC P0381 is not detected. Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure.