hitachi — DTC: P0487 (Flash code 44) EGR position sensor fault

Electronic control fuel injection system (Common rail type) 1E-353 DTC:

P0487 (Flash code 44) EGR position sensor fault EGR position sensor signal Common rail pressure sensor signal G sensor signal EGR position sensor signal EGR position sensor signal 5V Engine control module (ECM) B+ B+ B+ 98 E-56 101 E-56 82 E-56 100 E-56 90 E-56 87 E-56 92 E-56 110 E-56 93 E-56 103 E-56 94 E-56 111 E-56 5 H-20 H-20 H-20 H-20 H-20 H-8 H-8 H-8 H-8 H-8 H-8 14 6 13 12 3 7 2 6 1 5 0.5 Br 0.5 L/W 0.5 L 0.75 L 0.75 GY 0.75 W/L 0.75 G/W 0.75 W/B 0.75 G/B 0.75 W/R 0.75 L/W 0.5 L/W 0.75 B/W 0.5 L 0.5 Br 1 E-80 2 E-80 6 E-80 3 E-80 7 E-80 4 E-80 8 E-80 5 E-80 1 E-112 2 E-112 3 E-112 1 E-113 3 E-113 2 E-113 W V U EGR position sensor/EGR motor EGR valve Common rail pressure sensor G sensor TSWG0080 Description of circuit The ECM provides 5 V to the EGR position sensors U, V, and W through 5-V power supply circuit, and grounds to the inside of the ECM through ground circuit.

Also, the EGR position sensor outputs polarity (ON/OFF) of any one of the EGR position sensors U, V, and W through respective signal circuit, to the ECM. The ECM detects the EGR valve position by counting the number of change in polarity. The ECM sets the DTC when all of the EGR position sensors U, V, and W output “ON” or “OFF” simultaneously. The EGR position sensor is installed inside the EGR valve. The EGR position sensor is the hall IC type sensor and is installed to 3 locations. It detects the motor phase based on each polarity output (ON/OFF). The EGR position sensor includes following circuits.

5-V power supply circuit Ground circuit EGR position sensor U signal circuit EGR position sensor V signal circuit EGR position sensor W signal circuit Main trouble symptom Operationality is not affected. Preconditions when DTC is set Main relay input voltage is 16V or more. DTC P1630 or P1635 is not detected.