1E-354 Electronic control fuel injection system (Common rail type) DTC set condition Diagnostic aid Input signals from EGR position sensors U, V, and W are all ON or all OFF. If the intermittent trouble is suspected, followings may be the cause. Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage.
Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Back-up mode Instruction to fully close EGR valve Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure).
The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Test description Numbers below indicate step numbers in the chart. 3. Check all the signal circuits of the EGR position sensors U, V, and W. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 Check for installation condition of the EGR valve connector, ECM connector and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair as required.
Is the trouble detected? — Go to Step 10. Go to Step 3.