hitachi — DTC: P0487 (Flash code 44) EGR position sensor fault

Electronic control fuel injection system (Common rail type) 1E-355 Step Action Value YES NO 3 1. Check for followings in the circuit between ECM and EGR position sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Short circuit to EGR position sensor ground circuit • Short circuit to ground • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 10. Go to Step 4. 4 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC.

Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds, and then start the engine. 4. Warm-up the engine until the engine coolant temperature exceeds 80°C (176°F). 5. Check the DTC. Is DTC P0487 detected? — Go to Step 5. Go to “Diagnostic aid”. 5 Replace the EGR valve (EGR position sensor). Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 6. —