1E-358 Electronic control fuel injection system (Common rail type) On-board check procedure for sensors 1. Disconnect the coupling connector, and check the sensor from engine harness connector. 2. Disconnect the connector from sensor, and short the wiring of sensor connector. 3. Check the harness from coupling connector for open circuit. If both steps 1 and 2 are faulty, repair the harness. Check from step 1 again. If only step 1 is faulty, replace the sensor. 3 1 2 4 Name 1. Coupling connector between engine — the machine 2. Machine harness 3. Sensor connector 4. Engine harness TSWG0197 Step Item to be checked Inspection method Measuring condition Terminal No.
Normal value Abnormal value 3 Open circuit/ high resistance Resistance measurement • Disconnect the EGR valve connector. • Key switch “OFF” 87 - EGR valve connector sensor power supply terminal 100 Ω or less 10 MΩ or more 4 Short circuit to ground circuit/ ground Resistance measurement • Disconnect the EGR valve connector. • Key switch “OFF” 92 - 101 93 - 101 94 - 101 92 - Ground 93 - Ground 94 - Ground 10 MΩ or more 100 Ω or less Open circuit/ high resistance Resistance measurement • Disconnect the EGR valve connector.
• Key switch “OFF” 92 - EGR valve connector position sensor signal W terminal 93 - EGR valve connector position sensor signal V terminal 94 - EGR valve connector position sensor signal U terminal 100 Ω or less 10 MΩ or more