hitachi — DTC: P0488 (Flash code 45) EGR valve control fault

Electronic control fuel injection system (Common rail type) 1E-359 DTC:

P0488 (Flash code 45) EGR valve control fault EGR position sensor signal Common rail pressure sensor signal G sensor signal EGR position sensor signal EGR position sensor signal 5V Engine control module (ECM) B+ B+ B+ 98 E-56 101 E-56 82 E-56 100 E-56 90 E-56 87 E-56 92 E-56 110 E-56 93 E-56 103 E-56 94 E-56 111 E-56 5 H-20 H-20 H-20 H-20 H-20 H-8 H-8 H-8 H-8 H-8 H-8 14 6 13 12 3 7 2 6 1 5 0.5 Br 0.5 L/W 0.5 L 0.75 L 0.75 GY 0.75 W/L 0.75 G/W 0.75 W/B 0.75 G/B 0.75 W/R 0.75 L/W 0.5 L/W 0.75 B/W 0.5 L 0.5 Br 1 E-80 2 E-80 6 E-80 3 E-80 7 E-80 4 E-80 8 E-80 5 E-80 1 E-112 2 E-112 3 E-112 1 E-113 3 E-113 2 E-113 W V U EGR position sensor/EGR motor EGR valve Common rail pressure sensor G sensor TSWG0080 Description of circuit Preconditions when DTC is set The EGR motor is installed inside the EGR valve.

The EGR motor is the brushless DC motor, and is driven by three phases. The EGR position sensor includes following circuits. EGR motor drive circuit U EGR motor drive circuit V EGR motor drive circuit W The ECM drives the EGR motor through the EGR motor drive circuits U, V, and W. The ECM outputs drive signals by the switching inside the ECM, and the motor rotates with the combination of three-phase signals. Also, the valve opening angle is controlled by duty. The ECM sets the DTC when the EGR motor drive duty is high and the difference between the target EGR position and actual EGR position is large. DTC P1630, P1635, P0487, or P0488 is not detected.

Main relay input power supply voltage is higher than 20 V but lower than 32 V. Difference between target EGR opening angle and actual one is 20% or less. DTC set condition Difference between target valve lift and actual position is more than 20%. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Main trouble symptom Operationality is not affected.