1E-360 Electronic control fuel injection system (Common rail type) Back-up mode Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part.
Instruction to fully close EGR valve Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Diagnostic aid Test description If the intermittent trouble is suspected, followings may be the cause.
Improper connection of harness connector Numbers below indicate step numbers in the chart. 5. Check all the EGR motor drive circuits U, V, and W. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 Is the scan tool (KW communication) available? — Go to Step 3. Go to Step 13. 3 1. Perform “EGR control test” using scan tool. 2. Press the “Up” “Down” soft key. 3. Check the value for “EGR position”. Is “EGR position” within the specified value? ±3% Go to Step 4. Go to Step 5. 4 Check the DTC again. 1. Clear the DTC.
Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Turn the key switch to “OFF” for more than 10 seconds, and then start the engine. 3. Warm-up the engine until the engine coolant temperature exceeds 80°C (176°F). 4. Check the DTC. Is DTC P0488 detected? — Go to Step 8. Go to “Diagnostic aid”.