hitachi — DTC: P0488 (Flash code 45) EGR valve control fault

Electronic control fuel injection system (Common rail type) 1E-361 Step Action Value YES NO 5 1. Check for followings in the motor drive circuit between ECM and EGR motor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • Short circuit to ground • Short circuit to power supply circuit or ignition power supply circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 11. Go to Step 6. 6 Replace the EGR valve. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed?

— Go to Step 7. — 7 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds, and then start the engine. 4. Warm-up the engine until the engine coolant temperature exceeds 80°C (176°F). 5. Check the DTC. Is DTC P0488 detected? — Go to Step 8. Go to Step 12. 8 Is EMPS available? — Go to Step 9. Go to Step 10. 9 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note:

EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 11. Go to Step 10.