hitachi — DTC: P0488 (Flash code 45) EGR valve control fault

1E-362 Electronic control fuel injection system (Common rail type) About EGR valve Name 1. Position sensor power supply (5 V) 2. Position sensor signal W 3. Position sensor signal V 4. Position sensor signal U 5. Position sensor ground 6. Motor drive W 7. Motor drive V 8. Motor drive U TSWG0158 Step Action Value YES NO 10 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 11. — 11 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC.

Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Warm-up the engine until the engine coolant temperature exceeds 80°C (176°F). 5. Check the DTC. Is DTC P0488 detected? — Go to Step 2. Go to Step 12. 12 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 13 1. Remove the EGR valve. 2. Check the EGR valve for anchoring, clogging, etc. 3. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 5. Go to Step 4.