hitachi — DTC: P0488 (Flash code 45) EGR valve control fault

Electronic control fuel injection system (Common rail type) 1E-363 EGR valve check Breaker box inspection procedure Perform the inspection in the following procedure if there is such an instruction to use breaker box in the step. After inspection, return to the diagnostic step. TSWG0150 Push the EGR valve with finger to make sure it opens/ closes smoothly. Also, make sure that the valve closes completely when the finger is released. Name 1. Breaker box 2. DMM Step Item to be checked Inspection method Measuring condition Terminal No. Normal value Abnormal value 5 Short circuit to power supply circuit Voltage measurement • Disconnect the EGR valve connector.

• Key switch “ON” 111 - Ground 103 - Ground 110 - Ground 0V 18V or more Short circuit to ground Resistance measurement • Disconnect the EGR valve connector. • Key switch “OFF” 111 - Ground 103 - Ground 110 - Ground 10 MΩ or more 100 Ω or less Open circuit/ high resistance Resistance measurement • Disconnect the EGR valve connector. • Key switch “OFF” 111 - EGR valve connector motor drive U terminal 103 - EGR valve connector motor drive V terminal 110 - EGR valve connector motor drive W terminal 100 Ω or less 10 MΩ or more