hitachi — DTC: P0522 (Flash code 294) Engine oil pressure sensor fault (low voltage fault, open circuit, ground short)

Electronic control fuel injection system (Common rail type) 1E-367 Step Action Value YES NO 5 1. Turn the key switch to “OFF”. 2. Disconnect the engine oil pressure sensor connector. 3. Turn the key switch to “ON”. 4. Check the value for “Engine oil pressure sensor” using scan tool. Is the “Engine oil pressure sensor” more than the specified value? 0V Go to Step 7. Go to Step 6. 6 1. Check for followings in the signal circuit between ECM and engine oil pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”.

• Short circuit to engine oil pressure sensor ground circuit • Short circuit to ground 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 11. Go to Step 8. 7 Replace the engine oil pressure sensor. Is the procedure completed? — Go to Step 11. — 8 Is EMPS available? — Go to Step 9. Go to Step 10. 9 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM.

Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 11. Go to Step 10. 10 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 11. —