1E-368 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 11 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is the DTC P0522 detected? — Go to Step 2. Go to Step 12. 12 1. Start the engine. 2. Check the display of engine oil pressure. Does the display of engine oil pressure show error value? 1016 kPa (147.4 psi) (Displayed error value) Go to Step 13. Go to “Diagnostic aid”.
13 Check for installation condition of the engine oil pressure sensor, ECM and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 11. Go to Step 14. 14 1. Check for followings in the signal circuit between ECM and engine oil pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Short circuit to engine oil pressure sensor ground circuit • Short circuit to ground 2. If the trouble is detected, repair or replace as required. Is the trouble detected?
— Go to Step 11. Go to Step 7.