hitachi — DTC: P0522 (Flash code 294) Engine oil pressure sensor fault (low voltage fault, open circuit, ground short)

1E-370 Electronic control fuel injection system (Common rail type) Breaker box inspection procedure Perform the inspection in the following procedure if there is such an instruction to use breaker box in the step. After inspection, return to the diagnostic step. Name 1. Breaker box 2. DMM On-board check procedure for sensors Name 1. Coupling connector between engine — the machine 2. Machine harness 3. Sensor connector 4. Engine harness 3 1. Disconnect the coupling connector, and check the sensor from engine harness connector. 2. Disconnect the connector from sensor, and short the wiring of sensor connector. 3. Check the harness from coupling connector for open circuit.

If both steps 1 and 2 are faulty, repair the harness. Check from step 1 again. If only step 1 is faulty, replace the sensor. 1 2 4 TSWG0197 Step Item to be checked Inspection method Measuring condition Terminal No. Normal value Abnormal value 6 Short circuit to ground circuit/ ground Resistance measurement • Disconnect the sensor connector. • Key switch “OFF” 67 - 79 67 - GND 80 - 79 80 - GND 10 MΩ or more 100Ω or less