hitachi — DTC: P0523 (Flash code 295) Engine oil pressure sensor fault (high voltage fault, short to power supply, ground short)

Electronic control fuel injection system (Common rail type) 1E-371 DTC: P0523 (Flash code 295) Engine oil pressure sensor fault (high voltage fault, short to power supply, ground short) (*: Specifications vary depending on each machine.

Refer to the machine’s manual.) Engine control module (ECM) Vehicle speed sensor signal SV SV Engine oil pressure sensor signal SV CKP HIGH signal CKP LOW signal Fuel temperature sensor signal Engine coolant temperature sensor signal Vcc 108 E-56 19 E-57 107 E-56 106 E-56 83 E-56 84 E-56 79 E-56 67 E-56 80 E-56 3 H-6 H-20 H-20 H-20 H-20 7 11 10 9 3 H-20 H-20 H-20 2 1 0.75 B/Y 0.75 L/Y 0.75 W/B 0.75 Y/G 0.75 B/Y 0.75 R/B 0.75 B/Y 0.75 B Pulse matching box 2 E-93 1 E-93 1 E-90 2 E-90 1 E-76 E-76 E-76 2 3 0.5 V/W 0.5 Y 2 E-98 1 E-98 Fuel temperature sensor Engine oil pressure sensor Engine coolant temperature sensor 3 E-90 CKP sensor * A CAN HIGH CAN LOW Engine control module (ECM) 0.75 R Vehicle speed sensor 37 E-57 18 E-57 A 4 H-6 Meter CAN HIGH CAN LOW Machine control unit Engine coolant temperature gauge Machine trouble diagnosis monitor TSWG0078 Description of circuit Main trouble symptom The engine oil pressure sensor detects the engine oil pressure.

The engine oil pressure sensor is installed near the starter motor of the cylinder block. The resistance value in the engine oil pressure sensor changes according to the pressure. If the pressure is high, the resistance becomes low; if the pressure is low, the resistance becomes high. The engine control module (ECM) is connected to the engine pressure sensor via power supply circuit, signal circuit and ground circuit, and energizes +5 V power supply to the power supply circuit.

The ECM detects the signal voltage change in response to the change in resistance according to the engine pressure sensor pressure (If the pressure is high, the voltage becomes high; if the pressure is low, the voltage becomes low) as a signal. Operationality is not affected. Preconditions when DTC is set Key switch input voltage is 16V or more. DTC P1634 is not detected. DTC set condition Engine oil pressure sensor voltage is 4.85 V or more. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on.