1E-386 Electronic control fuel injection system (Common rail type) Recovery from failure The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2.
Go to “OBD system check”. 2 Is the scan tool available? — Go to Step 3. Go to Step 12. 3 1. Make sure all the communication between ECU and scan tool is normal. 2. Make sure the system which require programming operates normally. 3. Check the DTC. Is DTC P0611 detected? — Go to Step 4. Go to Step 10. 4 1. Check for followings in the ground circuit between ECM terminals (1, 3, 4, 43, 62, 81) and ECM ground terminal (E2) using breaker box or DMM. • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 10. Go to Step 5. 5 1. Turn the key switch to “OFF”. 2. Remove the ECM ground terminal (E2). 3.
Check the ECM ground terminal (E2) for intermittent trouble or poor contact. 4. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 10. Go to Step 6. 6 1. Turn the key switch to “OFF”. 2. Remove the ECM. 3. Check the ECM terminals (1, 3, 4, 43, 62, 81) for intermittent trouble or poor contact. 4. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 10. Go to Step 7. 7 Is EMPS available? — Go to Step 8. Go to Step 9.