Electronic control fuel injection system (Common rail type) 1E-387 Step Action Value YES NO 8 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 10. Go to Step 9. 9 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM.
Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 10. — 10 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P0611 detected? — Go to Step 2. Go to Step 11. 11 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 12 Is DTC P0611 detected? — Go to Step 4.
Go to Step 10.