1E-388 Electronic control fuel injection system (Common rail type) DTC: P0612 (Flash code 34) Charge circuit fault (bank 2) CAN HIGH CAN LOW Engine control module (ECM) KWP2000 52 E-57 38 E-57 37 E-57 4 E-57 3 E-57 1 E-57 43 E-57 62 E-57 81 E-57 18 E-57 6 FL-150 7 FL-150 DLC 4 FL-150 5 FL-150 Machine control unit CAN HIGH CAN LOW TSWG0074 Description of circuit Preconditions when DTC is set The charge circuit inside the ECM is the voltage pressurizing circuit to apply voltage to the injector, and is divided in to two systems for each 3 cylinder. The charge circuit 2 supplies the power supply voltage to the injectors of No. 4 cylinder, No. 5 cylinder, and No. 6 cylinder.
The ECM sets the DTC when the voltage in the charge circuit 2 is excessively high or excessively low. Main relay power supply voltage is 16V or more. DTC set condition When ECU charge circuit bank 2 voltage is low. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Main trouble symptom Intense engine vibration Rough idling Output lowering Engine blow up fault Engine stall possible Back-up mode • Specified back-up value