hitachi — DTC: P0650 (Flash code 77) Diagnosis lamp circuit fault

Electronic control fuel injection system (Common rail type) 1E-397 DTC: P0650 (Flash code 77) Diagnosis lamp circuit fault (*: Specifications (fuse current value etc.) vary depending on each machine.

Refer to the machine manual.) (15A)* A A Machine trouble diagnosis monitor Meter Tachometer Diagnosis lamp Engine oil pressure lamp QOS indicator lamp Boost temperature lamp Machine control unit CAN HIGH CAN LOW Engine control module (ECM) 37 E-57 18 E-57 6 E-57 8 E-57 17 E-57 11 E-57 7 E-57 Diagnosis lamp control Engine oil pressure lamp control QOS indicator lamp control Boost temperature lamp control CAN HIGH CAN LOW Tachometer signal TSWG0075 Description of circuit Preconditions when DTC is set The power supply voltage is supplied to the diagnosis lamp via key switch, and the signal from ECM will turn the lamp on.

The ECM turns the diagnosis lamp on during lamp check with the key switch “ON” and when DTC is detected. Also when the diagnosis connector is connected, it blinks the diagnosis lamp according to the DTC detected. A monitor circuit is provided inside the ECM to monitor the lamp operation. The ECM sets the DTC when the output to the diagnosis lamp does not match with the check engine lamp operation. Key switch input voltage is 16V or more. DTC P0650 is not detected. DTC set condition No diagnosis lamp monitor signal exists. Back-up mode Back-up:

No back-up action Recovery from failure Main trouble symptom Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. Operationality is not affected.