hitachi — DTC: P0615 (Flash code 19) Starter cut relay circuit fault

1E-396 Electronic control fuel injection system (Common rail type) Breaker box inspection procedure Perform the inspection in the following procedure if there is such an instruction to use breaker box in the step. After inspection, return to the diagnostic step. Name 1. Breaker box 2. DMM Step Item to be checked Inspection method Measuring condition Terminal No. Normal value Abnormal value 7 Short circuit to ground Resistance measurement • Disconnect the relay. • Key switch “OFF” 14 - Ground 10 MΩ or more 100Ω or less Open circuit/ high resistance Resistance measurement • Disconnect the relay.

• Key switch “OFF” 14 - Relay installing terminal 100Ω or less 10 MΩ or more 10 Short circuit to ground Resistance measurement • Disconnect the key switch connector. • Key switch “OFF” 46 - Ground 10 MΩ or more 100 Ω or less Open circuit/ high resistance Resistance measurement • Disconnect the key switch connector. • Key switch “OFF” 46 - Key switch “START” terminal 100 Ω or less 10 MΩ or more 12 Short circuit to power supply circuit Voltage measurement • Disconnect the relay. • Key switch “ON” 14 - Ground 0V 18V or more