Electronic control fuel injection system (Common rail type) 1E-395 Step Action Value YES NO 15 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 17. Go to Step 16. 16 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM.
Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 17. — 17 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds, and then start the engine. 4. Check the DTC. Is DTC P0615 detected? — Go to Step 2. Go to Step 16. 18 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair.