hitachi — DTC: P1094 (Flash code 226) No pump pressure feed (1st stage)

1E-418 Electronic control fuel injection system (Common rail type) About common rail pressure sensor Breaker box inspection procedure Perform the inspection in the following procedure if there is such an instruction to use breaker box in the step. After inspection, return to the diagnostic step. 1 2 3 TSWG0055 Name 1. Sensor ground 2. Sensor signal 3. Sensor power supply Name 1. Breaker box 2. DMM Characteristics of common rail pressure sensor (V) 4.2 1 0 200(29008) MPa(psi) TSWG0201 Step Item to be checked Inspection method Measuring condition Terminal No. Normal value Abnormal value 9 Short circuit to other signal circuit Voltage measurement • Disconnect the sensor connector.

• Key switch “ON” 82 - Ground 90 - Ground 0V 1V or more